SATA AE1031H Bedienungsanleitung Seite 124

中文
EN DE RU KO PT JA ES
AE1031H
8-11100087 (see the paragraph "TABLE FOR USING CENTRING AND CLAMPING
ACCESSORIES IN RELA.TION TO WHEEL TYPE" in this manual).
Deciding on which side of the wheel to demount the tyreSee fig. 18. Find the
position of rim well A on the rim. Find the largest width B and the smallest
width C. The tyre must be mounted and demounted with the wheel on the
turntable with the smallest width side C facing upwards.
Special wheels
Alloy rim wheels : some alloy rim wheels have minimal rim wells A or no rim
wells at all.Fig. 19a. These rims are not approved by DOT standards (Department
of Trans.portation). The DOT initials certify that tyres comply with the safety
standards adopted by the United States and Canada
(these wheels cannot be sold in these markets).
High-performance wheels (asymmetric curvature).Fig. 19-b: some European
wheels have rims with a very pronounced curvature C, except in the area of
the valve hole A where the curvature is less pronounced B. On these wheels
the bead must first be broken in the area of the valve hole, on both the top and
bottom sides.
Wheels with pressure sensor . Fig.19c. To work correctly on these wheels without
damaging the sensor
(which may be incorporated in the valve, fixed to the belt, adhered to the
interior of the tyre etc.), appropri.ate mounting and demounting procedures
must be observed (see the "Approved procedure for mounting/ demounting
runflat and UHP tyres").
CAUTION!
The TPMS device (optional) may only be used to test the function of pressure sensors.
124