Chapter Iii Operation Procedure Of The Wheel Aligner - SATA AE5601 Bedienungsanleitung

Chapter III Operation procedure of the wheel aligner

3.1 Preparations and restrictions for four-wheel alignment
Preparations include:
1.Check that the dowel pin for the turntable and the measuring slide plate is at the working position.
2.Adjust the position of the turntable according to the track of the vehicle, and ensure that all wheels are centered on the turntables to
avoid measurement error.
3.Drive the vehicle onto the lift, set the shift lever to Neutral position, release the parking brake, block the rear wheels with rubber blocks to
prevent the vehicle from moving.
4.Check the rim size and tire pressure, check the wear of tires and the status of various components of steering system and suspension
system such as tie rod ball, shock absorber, etc. In case of any non-conformity, do troubleshooting before four-wheel alignment.
5.Pull out the dowel pin for the turntable and the rear slide plate, press down the front and rear parts of the body with force to free the
wheels, properly straighten the steering wheel, and then install the dowel pin for the turntable and the side slide plate.
6.Install the fixture and the reflector, and ensure that the four clamping jaws of each fixture fit closely with the edge of the rim, and each
reflector corresponds to a wheel.
7.Properly adjust the reflector.
3.2 Home page
Welcome to use the SATA 3D four-
wheel alignment system!
①→
Model selection and measurement
②→
Target monitoring
③→
System management
④→
Customer management
⑤→
Exit
50
AE5601
→
→
Monitor the target board to raise the lift to the appropriate position (Fig. 2)
→
Adjust the settings of the system
→
Customer information database
→
Exit the interface
中文
EN DE
Camera monitoring
Left camera
Exit
Save
Select model and start measurement
RU KO PT JA ES
透明度拼合
Right camera