Mounting - SATA AE1031H Bedienungsanleitung

5.4.d. MOUNTING
Always check that the tyre/rim combination is correct in terms of compatibility (tube.less tyre on tubeless rim; tube
type tyre on tube type rim) and geometrical size (keying diameter, cross-section width, off-set and shoulder profile)
before mounting.
Also check that rims are not deformed, that their fixing holes have not become oval, that they are not encrusted or
rusty and that they do not have sharp burrs on the valve holes. Make sure that the tyre is in good condition without
any signs of undue wear or damage.
1.Carefully lubricate the sides of the tyre along the entire circumference
of the bottom and top bead (Fig. 23a).
2.Manually adjust the tyre so that the upper shoulder of the rim passes
the lower bead and goes into the well.
3.Press the button to move the demount-ing tool to the work
position (Fig. 23b).
4.Move the lever downwards to apply pressure on the tyre (Fig.
23c).
5.Keep the section of the tyre with the lower bead not yet inserted in the
rim partially depressed and turn the
bead is completely inserted.
6.Position the bead presser to the side of the mounting tool.
N.B.: If necessary, also use the bead pressing tool clamps.
7.Operate the control to lower the bead pressing tool until the
upper bead is in the well (see Fig. 23d).
130
AE1031H
turntable until the first
中文
EN
CAUTION!
DE RU KO PT JA ES