E.air Pressures; Additional Notes Regarding The; Intended Use Of The Machine; Employee Training - SATA AE1031H Bedienungsanleitung

1.2.e. AIR PRESSURES
The machine is equipped with an internal pressure limiting valve to minimize the risk of over inflating the tyre.
•EXPLOSION HAZARD
•Do not exceed the pressure recommended by the tyre manufacturer. Always match the tyre and
rim dimensions.
•Avoid personal injury or death
1. Never exceed these pressure limitations:
• Supply line pressure (from compressor) is 220 psi (15 bar).
• The operating pressure (indicated on the regulator) is 145 psi (10 bar).
• The tyre inflation pressure (displayed on the pressure gauge) must never exceed the pres.sure indicated by the manufacturer
on the sidewall of the tyre itself.
2. Activate the air inflation jets only when inserting the bead.
3. Bleed air pressure system before disconnecting supply line or other pneumatic compo.nents. Air is stored in a reservoir for
operation of inflation jets.
4. Only activate the air inflation jets if the wheel is clamped correctly on the tyre changer and the tyre is completely mounted.

1.3.ADDITIONAL NOTES REGARDING THE

Wheels equipped with pressure sensors and special wheels or tyres may require additional special procedures.
Consult the service manuals from the manufacturer of the wheels and tyres.

1.4. INTENDED USE OF THE MACHINE

This machine must only be used to demount and mount vehicle tyres from/on the rims, us.ing the provided tools. Any other use is improper and can result in an
accident.
The machine is not intended for working with motorcycle wheels.

1.5. EMPLOYEE TRAINING

1. The employer is responsible for providing a training program for all employees working on wheels concerning the hazards involved in wheel maintenance and
the necessary safety proce.dures to be observed. The terms 'service' and 'maintenance' refer to all activities involved in mounting and
110
AE1031H
CAUTION!
中文
EN DE RU
DANGER
KO PT JA ES