SATA AE1031H Bedienungsanleitung Seite 161

-Press the button (1, Fig. 50f) to take a sensor reading (Fig. 50e).
-Once the value is read, the data entry screen appears as shown in Fig. 50f, with the sensor data automatically compiled.
In some cases, the sensor conveys data only if tyre pressure changes by at least 0.2. For these sensors, the message
DEFLATE WHEEL will appear on the display, so a pressure change is required to enable valve transmission.
If the reading is not acquired, the message "Valve not recognised" is
shown on the display (Fig.50g). Check that the sensor is positioned
correctly and press
problem persists, check if the sensor is damaged.
Replace the sensor if damaged, following the in¬structions in the
section relative to sensor date (2, Fig. 50h).
-At the end of the procedure, press the
exit the programme, then repeat the procedure to test sensor function
-Press the button to exit the TPMS function and e return to the
main screen.
NOTE: At the next activation of the TPMS device the screen in Fig. 50f will be displayed with the data of the previous
vehicle. Press button 3, Fig. 50f to select a new vehicle or button 1, Fig. 50f for a new sensor reading.
TROUBLESHOOTING
The TPMS does not respond
Sensor connector disconnected
-Connect the connector (see Fig. 50i)
The sensor assembled on the valve is broken
-Check TPMS operation with another sensor faulty TPMS
-If the problem persists, contact the technical
AE1031H
CAUTION!
to repeat the procedure (1, Fig. 50g). If the
button (1, Fig. 50h) to
中文
EN DE RU KO PT JA ES
161