Removing The Back Panel Cover; Emergency Opening Of The Multi-Purpose Drawer - VHF Z4 Originalbetriebsanleitung

Z4 – Operation: Executing jobs

7.6 Removing the back panel cover

You need to remove the back panel cover of the
machine for an emergency release of the multi-
purpose drawer.
You can remove the back panel cover as follows:
1. Switch off the machine at the main power switch.
2. Disconnect the machine from all lines.
3. Grab the bottom edge of the back panel cover and
pull it towards you as indicated by the arrows:
F . 61 R
IG EMOVING THE BACK PANEL COVER
4. To re-install the back panel cover, do the following:
a. Align the top edge of the machine and the
cover so that the start button and main power
switch lie in the center of the respective open-
ings.
b. Push the cover against the machine housing.
The cover is held in place by magnets.
7.7 Emergency opening of the
multi-purpose draw er
In case of a longer power failure, you can manually
open the multi-purpose drawer as follows:
1. Remove the back panel cover (
2. Insert a screwdriver with 5 cm minimum length
F
IG
3. Push the screw driver in the upper right direction
4. Use the screwdriver to push the lever for the emer-
5. Install the back panel cover.
Original Operating Instructions: Z4
Version: 12/15/2021
).
panel cover – see above
into the depicted opening at the backside of the
machine.
. 62 E
MERGENCY RELEASE OF THE MULTI
until you encounter a resistance.
gency release to the left until the mechanism is
unlocked.
EN 53
Removing the back

-
PURPOSE DRAWER