VHF Z4 Originalbetriebsanleitung Seite 23

Z4 – Installing the machine
Accessing the DENTALCAM & DENTALCNC
installation folder
You can access the DENTALCAM & DENTALCNC install-
ation folder via Windows
®
1. Start Windows Explorer on the CAD computer.
®
In the folder and device list in the left column,
the CAM computer name displays under the Net-
work node. The name is identical to the serial
number of the machine (
tification plate & serial number – on page 12
Example: Z4ID212345678
F . 14 T CAM
IG HE COMPUTER NAME DISPLAYS IN
E
XPLORER
2. If there is no entry for the CAM computer, check
whether the CAD computer is correctly integ-
rated into the same network as the CAM com-
puter.
3. Select the entry for the CAM computer.
You are prompted to enter the login credentials.
4. Enter the following login credentials:
User: cnctransfer
n
Password: cnctransfer
n
5. Activate the Save login credentials option.
6. Access the files on the CAM computer as you
would with any other device.
Configuring the WiFi connection
The machine uses a pre-installed WiFi device to
connect to your access point.
1. Ensure the following:
Your WiFi access point is operational.
n
You have fully prepared your CAD computer
n
and the machine as described above (
paring the machine and CAD computer – on
).
page 19
2. Access the CAM computer via the Remote Desktop
application or direct hardware connection.
3. Configure Windows on the CAM computer for
®
WiFi connectivity:
a. Open the Windows
b. Activate WiFi for the corresponding adapter.
Explorer as follows:
Location of the iden-

).
W
INDOWS ®
Pre-

network settings.
®
Original Operating Instructions: Z4
Version: 12/15/2021
c. Select a WiFi network which can be accessed
by the CAD and the CAM computer.
d. Configure the WiFi connection as required.
4. Activate WiFi access on your CAD computer.
5. Remove the Ethernet cable that connects your CAD
computer with the machine.
EN 23