Z4 – Operation: Preparing jobs
c. Switch on the machine at the main power
switch.
6. If Windows
and DENTALCNC seem to be running
®
fine, check if the network configuration and
CAD / CAM integration is set up according to the
installation instructions.
integration – on page 18
7. If the problem persists, contact customer service.
6.5 Opening & closing the w orking
chamber door
Damaging of the machine by
NOTICE
operating the working
chamber door inappropriately
The working chamber door is operated by electricity. If
you manually open or close the working chamber
door, you can damage the machine.
Manually open or close the working chamber door
only in case of an emergency.
Before you manually open or close the working
chamber door, read the respective information in
the chapter Operation: Executing jobs.
To open or close the working chamber
door, select the upper arrow of the depic-
ted icon on the touchscreen.
F
. 29 O
&
IG
PENING
CLOSING THE WORKING CHAMBER DOOR
CAD computer & network
Original Operating Instructions: Z4
Version: 12/15/2021
6.6 Opening & closing the multi-
purpose draw er
Damaging of the machine by
NOTICE
operating the multi-purpose
drawer inappropriately
If you open the multi-purpose drawer by force, if you
do not maintain it properly or if you do not remove
leaked cooling liquid, the machine may get damaged.
Before you pull out the multi-purpose drawer,
unlock it.
Check regularly if the area below the cooling liquid
tank is dry and remove leaked cooling liquid imme-
diately.
1. To unlock the multi-purpose drawer,
select the lower arrow of the depicted
icon in the Home section of the touch-
screen.
After a couple of seconds, the drawer will open.
2. Pull the drawer open.
F
. 30 O
-
IG
PENING THE MULTI
PURPOSE DRAWER
3. To close the multi-purpose drawer, push it until it
locks back in place.
You will hear a clicking sound.
EN 35