Exchanging The Carbon Filter - VHF Z4 Originalbetriebsanleitung

Z4 – Maintenance and do-it-yourself
F . 85 G
IG REASING THE COLLET CHUCK
;
TO BE APPLIED IS MARKED IN BLUE SLOT THAT MAY NOT BE GREASED IS
MARKED IN RED
11. Check the condition of the fixing screw and replace
it by a spare screw if necessary.
12. Push the collet chuck with fixing screw into the
blank holder as far as you can. Twist the collet
chuck until it snaps in place and is properly seated.
Depending on the position you may need to twist
it up to 360°.
F . 86 I
IG NSERTING THE COLLET CHUCK INTO THE BLANK HOLDER
13. Insert the bit of the torque screwdriver into the col-
let chuck and hold it in place.
14. Put the torque screwdriver on the bit and screw
down the screw by twisting the torque screw-
driver.
;
SURFACE IN WHICH GREASE IS
Original Operating Instructions: Z4
Version: 12/15/2021

8.11 Exchanging the carbon filter

The cooling liquid tank of your machine is equipped
with a cooling liquid filter that consists of different filter
materials and includes the carbon filter. The carbon
filter contains activated carbon pellets that you need to
exchange regularly.
F . 87 C
IG OOLING LIQUID FILTER IN THE TANK
F . 88 T
IG HE COMPONENTS OF THE COOLING LIQUID FILTER
1. Fine filter
2. Carbon filter cap
3. Carbon filter
4. Mesh filter
To exchange the activated carbon pellets and clean the
filter, do the following:
EN 63