Removing The Transport Lock - VHF R5 Originalbetriebsanleitung

EN 30

5.9 Removing the transport lock

Before operating the machine for the first time, you
must remove the transport lock. The transport lock
prevents the spindle from getting damaged during
transport.
1. Ensure the following:
The network connection to your machine has
n
been properly configured.
The machine is connected to the electrical
n
source.
The CAM computer is connected to your
n
machine.
2. Switch on the machine at the main power switch.
3. Start DENTALCNC. Wait until the connection to the
machine has been established.
The machine references.
4. Open the working chamber door by
selecting the depicted icon in the Machin-
ing view in DENTALCNC.
5. Open the blank holder by selecting the
depicted icon in the Machining view in
DENTALCNC.
6. Remove the transport lock as shown in the sup-
plement.
Original Operating Instructions: R5
Version: 12/16/2021
R5 – Installing the machine