Mounting & Removing Blanks - VHF Z4 Originalbetriebsanleitung

EN 46
F . 52 T 2
IG HE HOLES IN A TOOL MAGAZINE
1. Larger front hole
2. Smaller rear hole
F . 53 P
IG LUGGING A TOOL MAGAZINE ONTO THE TOOL MAGAZINE
3
HOLDER IN STEPS
a. Position the larger rear hole on the longer
bolt of the tool magazine holder. Push it onto
the bolt until you feel a resistance.
b. Overcome the resistance by pushing the tool
magazine harder onto the bolt.
c. Align the smaller front hole with the shorter
bolt of the tool magazine holder. Push the
tool magazine onto the short bolt until it is
properly seated on the tool magazine holder.
6.11 Mounting & removing blanks
The machine can process the following blanks:
requires extra equipment
*
Mounting & removing blocks
You can mount blocks to the block holder where a
collet chuck immobilizes them. The collet chuck opens
and closes with the working chamber door.
1. Open the working chamber door.
2. Pull the block out of the holder if any.
3. Check the collet chuck for dirt.
4. If necessary, clean the collet chuck.
5. Place the required block in the collet chuck of the
F
IG
AND POSITIONING PIN MARKED ORANGE
1. Groove of the block
2. Positioning pin of the block
6. Push the block into the block holder until it clicks
Original Operating Instructions: Z4
Version: 12/15/2021
Z4 – Operation: Preparing jobs
Blocks, max. size: 45 x 20 x 20 mm (L/D/H)
n
Prefabricated abutments
n
You can obtain extra equipment from customer
service.
The working chamber door is open. The collet
chuck is open.
collet chuck of the blank holder – on page 62
block holder: Align the groove of the block [1] with
the positioning pin of the block holder [2].
. 54 I
NSERTING THE BLOCK INTO THE BLOCK HOLDER
)
in. If the block does not click in, twist it until the
positioning pin lies in the groove.
*
Cleaning the

(
GROOVE