VHF Z4 Originalbetriebsanleitung Seite 45

Z4 – Operation: Preparing jobs
F . 47 R
IG EMOVING THE PROTECTIVE CAP
SCREW
2. Remove the tool magazine from the working cham-
ber.
3. To reset the screw, do the following:
a. Using the provided allen key, turn the screw
to the left into its original position.
b. Cover the screw opening with the protective
cap.
The screw is reset and the tool magazine is
ready to be mounted again.
F . 48 R
IG ESETTING THE SCREW
CAP
You can use the touchscreen to choose the right tool
magazine for the next job:
1. To open the Jobs section, select the
depicted icon.
The Jobs section displays. The details of the next
queued job display.
2. If necessary, switch to the desired job by using the
left and right arrow in the left bottom corner of the
touchscreen.
F . 49 T
IG HE ARROWS TO SWITCH BETWEEN JOBS
( )
LEFT AND USING THE
( )
LEFT AND PLACING THE PROTECTIVE
Original Operating Instructions: Z4
Version: 12/15/2021
The touchscreen displays the required tool
magazine and if it is mounted into the working
chamber.
F . 50 T
IG HE TOOL MAGAZINE DETAILS IN THE
1. Check box to indicate if the required tool magazine is
mounted:
means not mounted
means mounted
2. The color code and letter of the required tool magazine.
Color codes of the tool magazines – on page 42

3. If an incorrect tool magazine is mounted, remove
this magazine by pulling it off the tool magazine
holder ( Fig. 46 on the previous page

arrow).
4. To mount the required tool magazine, identify it by
comparing the color code:
F . 51 T
IG HE COLOR CODE ON THE TOUCHSCREEN
THE TOOL MAGAZINE ARE IDENTICAL
5. Ensure that the contact surfaces of the tool
magazine holder and the tool magazine are clean.
You can only execute jobs when the
machine recognizes the required tool
magazine.
6. Plug the tool magazine onto the tool magazine
holder ( Fig. 46 on the previous page

arrow):
EN 45
J
OBS SECTION
, blue
( )
LEFT AND ON
, green