Cleaning The Working Chamber - VHF Z4 Originalbetriebsanleitung

EN 58
8.7 Cleaning the w orking chamber
Cleaning the working chamber includes the following
components:
Measuring key
n
Blank holder
n
View window
n
Webcam
n
Tool magazines
n
Tool magazine holder
n
These components have different maintenance inter-
vals according to the maintenance table. Therefore,
you should perform a daily and a weekly cleaning of
the working chamber and clean the components
which need cleaning.
When performing the weekly cleaning, also perform
the daily cleaning.
We recommend cleaning the working chamber
after all other required maintenance tasks.
Damaging of the linear guides
NOTICE
or the spindle when cleaning
with compressed air
If you clean the working chamber with compressed air,
material chips can reach the linear guides or the
spindle bearings.
Never clean the working chamber with compressed
air.
Do not pour additional water into the working
chamber. The cooling liquid tank may over-
flow.
1. Have ready:
A wet cloth
n
A mild cleaning agent (optional)
n
Cleaning brush for the blank holder
n
A wet brush for the measuring key
n
2. Open the working chamber door.
3. Clean all surfaces and cracks in the working cham-
ber thoroughly with a wet cloth. Use a mild clean-
ing agent if necessary.
4. Clean the measuring key with the wet brush (
67 see below ):
a. Clean every opening of the protective cage
(marked orange) with the wet brush.
Performing the weekly cleaning
1. Have ready: The cleaning brush for the blank
2. Remove the tool magazine from the working cham-
3. Open the multi-purpose drawer. Clean the other
4. Clean the blank holder with its respective brush.
F
IG
(
IN BLUE
1. Tool magazine holder
2. Measuring key, protective cage marked orange
3. Blank holder
5. Screw the protective cap off the webcam and clean
F
IG
6. Clean the webcam with a wet cloth. Screw on the
Fig.

7. Clean the tool magazine holder thoroughly.
8. Apply a bit of collet grease to the bolts of the tool
9. To apply the collet grease to the holes of all tool
Original Operating Instructions: Z4
Version: 12/15/2021
Z4 – Maintenance and do-it-yourself
b. Clean the measuring key from all sides with
the wet brush, reaching into the openings of
the protective cage.
c. Clean the protective cage with a cloth.
holder.
ber. Clean it with the cloth and the brush.
tool magazines.
. 67 T , M
OOL MAGAZINE HOLDER EASURING KEY
)
the inside of the cap with a dry cloth.
. 68 S
CREWING THE PROTECTIVE CAP OFF THE WEBCAM
protective cap.
magazine holder.
magazines, mount all tool magazines once.
, B
LOCK HOLDER