Operation: Preparing Jobs; Starting The Machine - VHF Z4 Originalbetriebsanleitung

EN 32
6 OPERATION: PREPARING
JOBS
Before you can machine blanks, you need to prepare
the machine. The corresponding jobs must have been
transferred to the machine so that they display on the
touchscreen.
NOTICE
If you switch off the machine or disconnect it from the
electrical source while the Windows
on the internal CAM computer is shutting down or
updating, the CAM computer may get damaged.
Without the CAM computer, the machine will not be
operational.
Updates may occur when you switch on the machine
and when you shut it down via the touchscreen. In
case of a major Windows
may take several hours.
Always shut down the machine via the touchscreen
before switching it off at the main power switch or
disconnecting it from the electrical source.
Always wait until the machine has completely shut
down before pressing the main power switch or dis-
connecting the machine from the electrical source.
When you switch on the machine, always wait until
the machine is fully operational. Do not switch it off
or disconnect it from the electrical source while it is
starting up.
Damaging of the internal CAM
computer
operating system
®
update, the update process
®
Original Operating Instructions: Z4
Version: 12/15/2021
Z4 – Operation: Preparing jobs

6.1 Starting the machine

Short-circuit hazard when the
NOTICE
machine is too cold
If the machine is transported from a cold environment
into a warmer environment, a short circuit may occur
caused by condensate.
Before switching on the machine after trans-
portation, ensure the following:
The ambient air has the allowed temperature.
n
The machine has the same temperature as the
n
ambient air. This will take at least 48 hours.
The machine is completely dry.
n
1. Ensure that the machine is properly installed.
2. Switch on the machine at the main power switch.
3. Press the start button.
The machine indicates on the touchscreen that it is
starting up.
F . 24 T
IG HE MACHINE IS STARTING UP
4. Wait until the machine has started up. This usually
takes up to 2 minutes, but can take significantly
longer in case of a Windows
The following happens:
a. The touchscreen indicates that the internal
CAM computer is connecting to the touch-
screen.
update.
®