Establishing The Electric Connection; Removing The Transport Lock; Removing The Protective Film; Checking The Tool Magazines In The Multi-Purpose Drawer - VHF Z4 Originalbetriebsanleitung

Z4 – Installing the machine
5.3 Establishing the electric con-
nection
Damaging of the machine
NOTICE
through heavy voltage
fluctuations and power surges
Heavy voltage fluctuations and power surges can
disrupt the control unit and can cause system failures.
Connect the machine to a dedicated current circuit
or ensure that no devices are connected that can
cause heavy voltage fluctuation when switched on.
If heavy voltage fluctuations cannot be avoided,
install a surge protector that protects the machine
from heavy voltage fluctuations.
Short-circuit hazard when the
NOTICE
machine is too cold
If the machine is transported from a cold environment
into a warmer environment, a short circuit may occur
caused by condensate.
Before switching on the machine after trans-
portation, ensure the following:
The ambient air has the allowed temperature.
n
The machine has the same temperature as the
n
ambient air. This will take at least 48 hours.
The machine is completely dry.
n
The machine requires a continuous power supply for
proper operation.
1. Plug the provided power cable into the power con-
nection at the connection panel of the machine.
2. If power failures occur regularly at the installation
location or if there are frequent voltage fluc-
tuations, install an Uninterruptible Power Supply
(UPS), type online / VFI (IEC 62040-3, class 1).
If a power failure occurs during job execu-
tion, the tool may break and the blank may
be destroyed.
3. Insert the plug of the cable into a socket that is pro-
tected by a Residual Current Device / Ground Fault
Circuit Interrupter.

5.4 Removing the transport lock

Before operating the machine for the first time, you
must remove the transport lock. The transport lock
prevents the spindle from getting damaged during
transport.
1. Ensure the following:
2. Switch on the machine at the main power switch.
3. Press the start button.
4. Open the working chamber door by
5. Remove the transport lock as shown in the sup-

5.5 Removing the protective film

At delivery, the following pieces of protective film are
attached to the machine:
5.6 Checking the tool magazines in
the multi-purpose draw er
After you have removed the transport lock, you should
open the multi-purpose drawer and check the tool
magazines.
1. To unlock the multi-purpose drawer,
2. Pull the drawer open.
3. Remove all pieces of the protective film.
4. Remove the transport protection cover from the
5. Verify that there are 5 tool magazines with different
6. To close the multi-purpose drawer, push it until it
Original Operating Instructions: Z4
Version: 12/15/2021
The machine is connected to the electrical
n
source.
The machine references.
selecting the upper arrow of the depicted
icon on the touchscreen.
plement.
2 on the front machine housing
n
1 on the working chamber door
n
1 on the top cover
n
4 in the multi-purpose drawer
n
Before machine installation, carefully peel the pro-
tective film off the machine with your hands.
select the lower arrow of the depicted
icon in the Home section of the touch-
screen.
After a couple of seconds, the drawer will open.
tool magazines.
color codes in the drawer.
locks back in place.
You will hear a clicking sound.
EN 17