Switching Off The Machine; Opening & Closing The Working Chamber Door - VHF R5 Originalbetriebsanleitung

EN 32
The working chamber door closes. The machine is
ready for operation.
6.3 Sw itching off the machine
Danger of an electric shock if
DANGER
unplugging the power cable
before switching off the machine
If you unplug the power cable while the main power
switch is still in "ON" position, residual voltage in the
power cable may cause you to suffer from an electric
shock.
Before unplugging the power cable, switch off the
machine at the main power switch.
To switch off the machine, do the following:
1. Ensure that the working chamber is clean.
2. Switch off the machine at the main power switch.
3. (Optional) Unplug the power cable.
4. (Optional) Switch off the main power switch of
your workstation / facility.
6.4 Opening & closing the w orking
chamber door
chamber door inappropriately
The working chamber door is operated by electricity. If
you manually open or close the working chamber
door, you can damage the machine.
F
IG
Original Operating Instructions: R5
Version: 12/16/2021
R5 – Operation: Preparing jobs
Damaging of the machine by
NOTICE
operating the working
Manually open or close the working chamber door
only in case of an emergency.
Before you manually open or close the working
chamber door, read the respective information in
the chapter Operation: Executing jobs.
To open or close the working chamber
door, select the depicted icon in the
Machining view in DENTALCNC.
. 33 O &
PENING CLOSING THE WORKING CHAMBER DOOR