Bosch EPS 118 Originalbetriebsanleitung Seite 62

en 62 | EPS 118 | Product description
5.4.8 Inlet connector (special accessories)
The inlet connector (Fig. 7, item 2) is required for the
various test adapters (special accessories). Test adapt-
ers (Fig. 7, item 3) are used to supply the CRIN with
internal connections with test oil by way of the inlet
connector.
The return quantity of the CRIN is routed via hose as-
sembly 1 684 462 570 (see Fig. 9, item 1) with the CRIN
hose fitting 1 683 386 192 (see Fig. 9, item 4) from the
"Return quantity test connection" (Fig. 7, item 1) to the
"Return quantity test connection" (Fig. 3, item 3). There
are different designs of test adapters.
4
3
Fig. 7: Test adapter with inlet connector
1 Test connection for return quantity
2 Inlet connector
3 Test adapter
4 Mount for CRIN
|
1 689 989 300 2018-05-24
1
2
Installing the test adapter (CRIN)
i
In the EPS 118 software, the type part number of
the injector-specific test adapter can be displayed
after selecting the CRIN. Installation of the latest
EPS 118 software ensures that the type part num-
bers of all injector-specific test adapters (special
accessories) available are displayed.
3
Fig. 8: Installing the CRIN injector
1 CRIN
2 Test adapter
3 Inlet connector
1. Select the test adapter (Fig. 8, item 2).
2. Check the O-ring in the test adapter for damage
(e.g. cracks).
3. Shove the CRIN (Fig. 8, item 1) into the test adapter.
The high-pressure inlet bore hole of the CRIN must
be aligned with the hole for the inlet connector
(Fig. 8, item 3).
4. Turn the CRIN until the high-pressure inlet bore is
visible in the hole for the inlet connector.
!
Tightening torque must be adhered to when tighten-
ing the inlet connector. Too high tightening torque
can lead to pre-existing defect and breakage of the
inlet connector during the test.
5. Screw the inlet connector into the test adapter and
tighten.
Tightening torque 20 — 25 Nm.
1
2
Robert Bosch GmbH