Werbung
English
6.2.2
Preparing the robotic mower for opera‐
tion
► Remove the packaging material and transport
locks.
► Ensure that the following components are in a
safe condition:
– Robotic mower,
– Mowing unit,
– Battery,
4.6.3
– Docking station and power supply,
► Positioning the docking station,
► Installing the perimeter wire,
► Completing the perimeter wire installation,
6.5.1
► Installing the guide wire,
► Electrically connecting the docking station,
6.7.1
► Charging the robot mower,
► Locking the Bluetooth
► If you cannot carry out these steps: Do not use
the robotic mower and contact a STIHL
authorized dealer.
6.3
Positioning the docking station
6.3.1
General requirements
Wi-fi
► Choose the docking station location so that
the following conditions are met:
– The charging cable (1) can be installed out‐
side of the mowing area to connect to a suit‐
able wall socket.
– The docking station and power supply are
positioned in a clearly visible area.
– The docking station is in the mowing area
that is the largest or most frequently
mowed.
– If possible, protect the location against
adverse weather conditions and direct sun‐
light.
– If possible, the docking station is within
range of a wireless network (WLAN connec‐
tion).
– If possible, in a mowing area with a slope,
the docking station is in the lower area of
the slope.
90
4.6.1
4.6.2
6.3
6.4
6.6.1
6.8.1
®
radio interface,
1
6 Using the robotic mower as a stand-alone device
4.6.4
7.1
► Align the docking station so that the following
conditions have been met:
– The docking station has been positioned on
a level surface.
– The opening of the docking station is facing
forward toward the mowing area.
– The docking station has been aligned hori‐
zontally and is not tilted to the side, the front
or the rear.
– The base plate does not sag but rather lies
flat on the ground.
6.3.2
Positioning the docking station
The correct position of the docking station
depends on the planned location and its sur‐
roundings.
► Select the location and set up the docking sta‐
tion as described.
Positioning the docking station within the mowing
area
The docking station is at the edge of the mowing
area by a wall and the guide wire (1) can be
routed for a =2 m in a straight line from the dock‐
ing station to the mowing area.
a
90°
1
0458-036-9801-A
Werbung
