Werbung
English
Damaged or worn blades and the mowing unit
can be replaced.
► If the robotic mower, battery, docking station,
charging cable, power supply or connecting
cable is damaged: Do not use the robotic
mower, battery, docking station, charging
cable, power supply or connecting cable and
contact a STIHL authorized dealer.
► If a blade is damaged or worn:
► Stop the robot mower and activate the
device lock.
► Replace all blades. The blades cannot be
re-sharpened.
► If the blade disk or the L-pins on the blade disk
are damaged or worn:
► Stop the robotic mower and activate the
device lock.
► Replace the mowing unit.
► If warning labels are illegible or damaged:
Have the warning labels replaced by a STIHL
authorized dealer.
15.2
Extending or repairing perime‐
ter wire or guide wire
The perimeter wire or guide wire can be exten‐
ded or repaired using wire connectors.
Wire connectors are filled with gel to prevent pre‐
mature wear or corrosion of the wire ends.
► Make sure that the overall length of the perim‐
eter wires does not exceed the maximum
length of 850 m.
16 Troubleshooting
16.1
Troubleshooting the robotic mower
Most faults are indicated in the MY iMOW
docking station.
Proceed as follows for troubleshooting:
► Follow the instructions in the MY iMOW
or
► Press the LOCK pushbutton on the control panel and follow the audible instructions.
Error
Light strips on
the robot
mower or
docking station
The robotic
The light strip
mower interrupts
flashes red
the installation of
twice.
the team func‐
tion.
118
1
► Insert the wire ends (2) into the wire connec‐
tors (1).
Do not strip the wire ends.
► Press the wire connector (1) together up to the
limit stop with a pair of pliers.
► Route perimeter wires at least for a length of
a = 5 cm parallel and close together without
the perimeter wires crossing over each other.
®
app and by red light patterns on the robotic mower or
®
app.
Cause
There are already set‐
tings on the robotic
mower that are inter‐
fering with the team
function.
The sequence for
installing the team
function has not been
complied with.
2
Remedy
► Reset the robotic mower to the default
setting in the MY iMOW
► Reset all robotic mowers to the default
setting in the MY iMOW
► Install the team function in descending
order,
5.7.2.
16 Troubleshooting
a
®
app.
®
app.
0458-036-9801-A
Werbung
