Orthofix GALAXY UNYCO SYSTEM Anleitungsfaltblatt Seite 6

Systems, please be advised that this combination has not been tested in the MR environment and therefore higher heating and serious injury to the patient may occur. Because
higher in vivo heating cannot be excluded, close patient monitoring and communication with the patient during the scan is required. Immediately abort the scan if the patient
reports burning sensation or pain.
Galaxy UNYCO System can only be guaranteed for MRI when using the following components to build the frames:
Tibia frame
2 x Large Multiscrew Clamps for UNYCO Screws
1 x Rod Ø 12 mm L 350 mm
Up to 8 within these screws available in the kit:
8 x UNYCO Screw QC Shaft Ø 6 mm
4 x UNYCO Cancellous Screw QC Shaft Ø 6 mm
Ankle spanning – Delta frame
1 x Large Multiscrew Clamps for Unyco Screws
1 x Transfixing Pin Thread L80mm Shaft Ø 4mm, Thread Ø 5mm
2 x Rod Ø 12mm L 350mm
4 x UNYCO Cancellous Screw QC Shaft Ø 6mm
1 x Galaxy Large Clamp
2 x Galaxy Large-Medium Transition Clamp
6
Ankle spanning – Unilateral frame
1 x Large Multiscrew Clamps for Unyco Screws
1 x Radiolucent Foot Unit
2 x Rod Ø 12mm L 350mm
7 x UNYCO Cancellous Screw QC Shaft Ø 6mm
6 x Galaxy Large Clamp