Actim 1ngeni Bedienungsanleitung Seite 19

Step 3. Set LIS Server Port Number
Setting up communications to the LIS Server requires knowledge of the server credentials. Contact your IT
provider to acquire the IP Address & Port Number details of the LIS Server to be used.
• Select the "Port Number" option.
• Enter the Port Number of the LIS Server into the field provided.
The default value is provided is 51112. However, this number will be specific to the LIS Server you are using.
The number must lie between the following range: 49152 - 65535
Step 4. Test LIS Server Connection
To Test the connection between the Actim 1ngeni & the LIS Server, run the 'Test Connection' option:
• Select "Test Connection"
• One of three states will be displayed:
o Pending: Test Connection not yet run
o Success: Actim 1ngeni successfully connects to LIS
o Failed: Actim 1ngeni failed connection with LIS
Touch the OK icon, to apply confirm the applied IP & Port Number settings of the LIS Server.
Use the 'Clear Settings' option, to quickly clear all configured options within the LIS Setup menu.
Check Connectivity Status
• Connectivity Status
The user may access the Status screen to view transmission data statistics with the LIS Server.
To do this, navigate to the Data Connectivity menu under the Admin settings, then select the 'Connectivity
Status' option
• LIS Status
Under the LIS Status menu, the user can review the transmission stats with the LIS
Server.
The categories shown are:
• Unsent Results (results not yet sent to LIS)
• Total Results (total number of results in instrument memory)
• Test connection
The first user option shown is a repeat command also found under the LIS Setup menu.
The user can run the 'Test Connection' option from the LIS Status screen as well for convenience.
Admin user settings
19