Initial User Setup - Actim 1ngeni Bedienungsanleitung

Getting started
10

2.2 Initial user setup

After the admin user has set up the background settings,
the steps shown below are defined by the user.
To start:
• Connect the 12V power supply to the power connection
of the instrument.
• Log into the instrument
Enter settings by selecting the settings icon
(See Section 3 for detailed instructions).
Define the audio settings:
Define the network settings:
Define the printer setup:
Define screen brightness:
(See Section 3 for more information).
Fig 6.
Basic user
setup steps.
both touch tone and general tones used by the instrument can be adjusted
from the levels 0 to 5. It is also possible to listen to the test sound.
this allows you to configure the Ethernet connection of your instrument
this allows you to configure the printer connections of your instrument
adjust from 30% to 100%.
1) Power on
2) Log in
3) Define audio settings
4) Define network settings
5) Define printer setup
6) Set brightness