N N o o t t e e - - For more information about the P P e e d d i i - - M M a a t t e e ® infant restraint system, see the manufacturer's instructions for use,

operation, and care. Safe and proper use of the P P e e d d i i - - M M a a t t e e ® infant restraint system is at the discretion of the user. Set

methods and procedures to educate and train your staff on the safe operation or maintenance of this product. These are

general instructions only. Keep these instructions for future reference. These instructions are a permanent part of the

product and should remain with the product even if the product is sold.

P P e e d d i i - - M M a a t t e e ® is a registered trademark of Ferno Washington, Inc.

I I n n s s t t a a l l l l i i n n g g t t h h e e d d e e f f i i b b r r i i l l l l a a t t o o r r p p l l a a t t f f o o r r m m

W W A A R R N N I I N N G G - - Do not install the defibrillator platform on a Model 6086 P P e e r r f f o o r r m m a a n n c c e e - - P P R R O O XT cot with the P P o o w w e e r r - - L L O O A A D D

option to avoid the risk of a cot tip.

C C A A U U T T I I O O N N

• Always secure the defibrillator platform to the product when you use the defibrillator platform.

• Always use and adjust the straps that are provided with the defibrillator platform to secure the defibrillator.

• Always change the installation location or adjust the straps for your specific defibrillator size or shape.

• Do not load the defibrillator platform above the safe working load of 30 lb (13.6 kg).

To install the defibrillator platform:

1. Place the defibrillator platform in the stored position (Figure 24).

2. Open and expand the defibrillator platform legs (Figure 25).

F F i i g g u u r r e e 2 2 4 4 – – S S t t o o r r e e d d p p o o s s i i t t i i o o n n

3. If the product is equipped with an IV pole, raise the IV pole (A) to the up position (Figure 26).

4. Place the defibrillator platform on the product frame.

5. Position the inside legs (B) of the defibrillator platform toward the head end of the product (Figure 26).

6. Place the latch hook (C) under the litter frame or foot end fastener and push the tab (D) up until it locks into place on one

side with an audible click. Repeat on the other side. For P P o o w w e e r r - - L L O O A A D D compatible cots, if equipped, you must lengthen

and attach the straps to the foot end fastener (Figure 28).

6086-209-005 Rev I.1

F F i i g g u u r r e e 2 2 5 5 – – O O p p e e n n d d e e f f i i b b r r i i l l l l a a t t o o r r p p l l a a t t f f o o r r m m l l e e g g s s