Stryker Performance-PRO XT Bedienungsanleitung Seite 18

A
B
C
D
E
F
P P o o s s i i t t i i o o n n i i n n g g o o f f t t h h e e v v e e h h i i c c l l e e s s a a f f e e t t y y h h o o o o k k , , f f r r o o n n t t t t o o b b a a c c k k
Before vehicle safety hook installation, check the front to back and side to side positioning when you unload and load the
cot.
To check the front to back positioning:
1. Select the appropriate vehicle safety hook ( Selecting the vehicle safety hook (page 12)).
2. Position the vehicle safety hook at least 3-3/4 in. from the leading edge of the door sill (A). The recommended distance
from the face of the safety hook to be no less than 3-3/4 in.
3. Make sure that you can secure the vehicle safety hook to the mount in the back of the vehicle.
4. Make sure that you have adequate bumper clearance to allow the cot to be loaded and unloaded from the vehicle.
5. Confirm the side to side placement of the vehicle safety hook ( Positioning of the vehicle safety hook, side to side (page
15)).
EN 14
B
A
F F i i g g u u r r e e 4 4 – – D D e e c c k k a a n n d d b b u u m m p p e e r r h h e e i i g g h h t t
Deck height (DH)
Bumper height
Vehicle safety hook
Sill edge
Sill
Bumper depth
C D
E
A
B
F
6086-209-005 Rev I.1