Stryker Performance-PRO XT Bedienungsanleitung Seite 8

• Always transport the cot at a lower height to reduce the risk of a cot tip. If possible, obtain additional assistance or take
an alternate route.
• Always avoid high obstacles, such as curbing, steps, or rough terrain to avoid the risk of the product tipping over.
• Always keep hands away from the foot end release handle when you raise or lower the cot with the side release handle.
• Always remove your foot from the base tube when you are lowering the cot to the lowest position.
• Always use P P o o w w e e r r - - L L O O A A D D with the 6085/6086 P P e e r r f f o o r r m m a a n n c c e e - - P P R R O O XT, 6500/6506 P P o o w w e e r r - - P P R R O O XT, and 6510/6516
P P o o w w e e r r - - P P R R O O IT cots with the P P o o w w e e r r - - L L O O A A D D option only. In certain situations, you can use P P o o w w e e r r - - L L O O A A D D as a standard
antler for most X-frame cots, but a rail clamp assembly is required for all cots without the P P o o w w e e r r - - L L O O A A D D option.
• Always make sure that you use a P P o o w w e e r r - - L L O O A A D D date of manufacture cot with the Stryker Model 6390 P P o o w w e e r r - - L L O O A A D D
system to avoid the risk of injury.
• Always support the load of the patient, cot, and accessories after the weight is off of the ground.
• Always use two operators when a cot is occupied.
• Do not pull or lift on the cot safety bar when you unload the cot.
• Always lock the undercarriage before you remove the loading wheels from the vehicle patient compartment floor. An
unlocked undercarriage will not support the cot and injury to the patient or operator could result.
• Do not allow the cot undercarriage to drop unassisted (commonly known as a hot drop) when you remove the cot from
the vehicle. Repeated hot dropping causes premature wear or damage to the cot.
• Always lock the head section into place before you operate the cot.
• Do not load the cot into a vehicle with the head section retracted when using a cot fastener. The cot may tip or not
connect with the cot fastener.
• Do not install or apply a wheel lock on a product with worn wheels that are less than 6 in. diameter.
• Do not leave a patient or occupant unattended. Hold the product while a patient or occupant is on the product.
• Always use two operators when using the kickstand.
• Always center the patient weight on the cot before you use the kickstand.
• Always apply the kickstand with your foot only.
• Always lower the cot height before you apply the kickstand for increased stability.
• Do not apply the kickstand during transport. Keep the kickstand in the retracted position.
• Do not use the kickstand as a brake.
• Do not apply the kickstand on a sloped surface.
• Do not attach restraint straps to the base tubes or cross tubes.
• Always form an X with the waist restraint strap and the shoulder restraint strap.
• Always locate the buckle away from obstructions or accessories on the cot to avoid the risk of accidental release of
P P e e d d i i - - M M a a t t e e ® infant restraint system and injury to the infant.
• Do not install the defibrillator platform on a Model 6086 P P e e r r f f o o r r m m a a n n c c e e - - P P R R O O XT cot with the P P o o w w e e r r - - L L O O A A D D option to
avoid the risk of a cot tip.
• Do not use the oxygen bottle holder to hold an oxygen bottle holder when the transport vehicle is in motion. Always place
the oxygen bottle holder in an appropriate storage location when the transport vehicle is in motion.
• Always inspect the straps and clips for wear between use. Replace the strap if it no longer holds the oxygen bottle.
• Do not pinch your fingers between the Fowler bracket and the oxygen bottle if your cot is equipped with the optional
retractable head section oxygen bottle holder.
• Do not allow the head end storage flat (if equipped) to interfere with the operation of the retractable head section, safety
bar, or vehicle safety hook.
• Always use any appropriate personal protective equipment while power washing to avoid inhaling contagion. Power
washing equipment may aerate contamination.
C C A A U U T T I I O O N N
• Improper usage of the product can cause injury to the patient or operator. Operate the product only as described in this
manual.
• Do not modify the product or any components of the product. Modifying the product can cause unpredictable operation
resulting in injury to patient or operator. Modifying the product also voids its warranty.
• Always set the cot load height before you place the cot into service.
• Always clear any obstacles that may interfere and cause injury to the operator or patient before operating the product.
• Do not sit or stand on the siderails (XPS option).
EN 4 6086-209-005 Rev I.1