Stryker Performance-PRO XT Bedienungsanleitung Seite 45

F F i i g g u u r r e e 3 3 5 5 – – B B a a c c k k r r e e s s t t s s t t o o r r a a g g e e p p o o u u c c h h
I I n n s s t t a a l l l l i i n n g g t t h h e e o o p p t t i i o o n n a a l l h h e e a a d d e e n n d d s s t t o o r r a a g g e e f f l l a a t t
W W A A R R N N I I N N G G - - Do not allow the head end storage flat (if equipped) to interfere with the operation of the retractable head
section, safety bar, or vehicle safety hook.
C C A A U U T T I I O O N N - - Do not load the head end storage flat above the safe working load of 40 lb (18 kg).
To install the head end storage flat (Figure 36):
1. Install the V V e e l l c c r r o o ® straps (A) near the pneumatic cylinder and around the cross tube (C) of the retractable head section.
2. Buckle the restraint straps (B) around the outer rails of the retractable head section.
6086-209-005 Rev I.1 41 EN