Kubota D650-B Handbuch Seite 222

o
Removing Brush Holder
1) Draw out the brush from the holder while holding the
spring up.
2) Take off the brush holder.
(Note for reassembling)
• Be sure not to mistake the direction and position of the
spring.
• Do not contact the body with the positive brush's lead.
00 75P097
o
Removing Yoke
1) Draw out the yoke from the drive end frame.
(Note for reassembling)
• Take care yoke does not knock pin.
o
Removing Armature
•
1) Remove the set bolt from the drive lever .
2) Draw out the armature from the drive end frame.
3) Detach the d rive lever.
0075P099
(I
mportant)
• When reassembling, be sure not to mistake the installing
direction of the drive lever.
00 75PJOO
226