CD
Removing Gear and Camshaft
1) Draw the camshaft and the cam gear.
(Note for reassembling)
• Apply a thin film of engine oil to the camshaft before
installation.
(1) Camshaft assembly
«0
Removing Fork Lever Assembly
1) Remove the two fork lever holder mounting bolts.
2) Detach the fork lever assembly.
(Note for reassembling)
• Install the fork lever holder and crankcase after cleaning
their contact surfaces.
• Install the fork lever so that it will not hit the governor
sleeve, and so that equal space is allowed on either side
of the lever.
• After installation, check to see that the fork lever
(1)
is
fixed to the fork lever shaft, and that it can turn smoo
thly in the holder.
(1)
Fork lever assembly
_
Removing Fuel Camshaft
1) Remove the fuel camshaft stopper.
2) Draw out the fuel camshaft and the injection pump gear.
(Note for reassembling)
• Apply a thin film of engine oil to each part, and reassem
ble so that the drive groove at the end of the camshaft
engages with the drive shaft of the hydraulic gear pump.
• The balls to be contained in the governor ball case are
thirty 3.97 mm (0.1563 in.) diameter ones and eight
13.46 mm (0.5300 in.! diameter ones.
111
Fuel camshaft assembly
(2)
Fuel camshaft stopper
134