Kubota D650-B Handbuch Seite 172

(2) Checking Radial Clearance between Outer
Rotor and Pump Body
1) Insert a feeler gauge into the gap between the oil pump
body and the outer rotor and measure the clearance.
2) If the measurement exceeds the allowable limit, replace.
Reference
OOIlPIOI
Allowable limit
COl9F050
(3) Checking End Clearance between Rotor and
Cover
1) Paste a press gauge to the surface of the gear with grease.
2) Attach the cover.
3) Gently remove the cover. Measure the clearance by
placing the gauge (paper) on the press gauge where it is
crushed.
4) If the measurement is not within the reference value,
replace.
[~
Reference value
....--r--. .
0.08 toQi3 mm - - - - - - ,
I
0.0031 to 0.0051 in.
I
176