Kubota D650-B Handbuch Seite 134

~
,
CRANKSHAFT
o
Removing Oil Pan
1) Lay the engine on the engine cradle on its side.
2) Remove the eighteen oil pan mounting bolts.
3) Detach the oil pan by lightly tapping the groove of the
pan with a wooden hammer.
(Note for reassembling)
• Wipe off oil on the oil pan mounting surface, apply a non­
drying adhesive, and install the oil pan.
• To avoid uneven tightening, tighten mounting bolts in
diagonal order from the center.
• Check to see that the drain plug is tight.
(1)
Oil pan
8
Removing Oil Filter 1
1) Remove the mounting bolt of oil filter 1.
2) Detach oil filter 1, being careful of the a·ring.
(Note for reassembling)
• After cleaning the oil filter, check to see that the filter
mesh is clean, and install it.
• Visually check the O-ring, apply engine oil, and install it.
• After checking to see that the O-ring is securely installed,
attach the oil filter.
(1) Oil filter 1
138