Kubota D650-B Handbuch Seite 14

[AJ Applying grease to oil seal
[B] Direction of installing circlips
(4)
(3)
F-=-Q
~
I
~
(5)
(5)
1) When disassembling, arrange each part on a clean place.
Do not mix them up. Replace bolts and nuts where they
were.
2) When servicing voltaged places or connecting instruments
to electrical equipment, first disconnect battery negative
terminal.
3) If special tools are needed for repairing, use KUBOTA ­
supplied tools.
4) Replace gaskets or O-rings with new ones when disas ­
sembling, and apply grease on the O-ring and the oil seal
when reassembling.
5) When exchanging parts, use KUBOTA-genuine parts to
maintain engine performance and safety.
6) To prevent oil and water leakage, apply non-drying
adhesive to the gaskets according to this manual before
reassembl ing.
7) When hoisting up the engine, use the hook provided on
the cylider head.
8) When installing external circlips or internal circlips, direct
corner end to the non-loosening direction.
(1) Inside of lip
(2) Grease
(3) External circlip
(4) Internal circlip
15) Direct the corner end to the direction subiect to force.
18