11)
~.
/~
, , - \
(10)
. ' - \ \
(9)
(8)
m
\
(6)
00 75POl
5
o
Disassembling Nozzle Holder
1) Secure the retaining nut with a vise.
2) Remove the nut, the eye joint and the plain washer.
3) Remove the nozzle holder body and take out parts inside,
(Note for reassembling)
• When disassembling and reassembling the nozzle piece, dip
it in clean fuel.
• Install the push rod, noting its direction (upside down).
• Tighten the retaining nut to 58.8 to 78.4 Nm (6 to
8 kgf'm, 43.4 to 57.8 ft-Ibsl.
• Do
not tighten it too much, or the needle valve will not
slide easily and the injection performance will be
decreased.
(1 I
Retaining nut
(6)
Adjusting washer
(2)
Nozzle holder body
171
Nozzle spring
131
Nut
(S)
Push rod
(4)
Eye jOint
(9) Distance piece
(5)
Plain washer
(10)
Nozzle piece
122