WIKA Pascal ET Betriebsanleitung Seite 64

6. Commissioning, operation
Run the report and the instrument display:
EN
The display shows the status "Stabil. wait time" with the remaining time indication.
When the stabilization time is reached the instrument will enter the searching for stabilization:
The display show the parameter "Stabilization time". The value will came back to the starting value as soon as the
temperature goes outside the set range. The counting will start again and, starting from the new time counting, the instrument
will check that the temperature value will not change over the set range.
The stability is reached when the timing reach the zero. Then, the instrument will store the REF and DUT values and will start
with the next point by repeating the previous steps for all the points set for the report.
Importing the report on a PC by using the Pascal report software:
64 WIKA operating instructions, model Pascal ET