6. Commissioning, operation
By selecting the [Rtd] unit the screen changes as follows:
EN
10
Fig. 18 - Module IN A with Rtd unit selected
The calibrator set the unit in RTD and shows the last used RTD type (in this case the last used RTD type was Pt100 IEC).
It is also possible select an Rtd type "User" if not listed in the pre-defined options.
To select the Rdt type "User" press the button indicated with
on the figure previous.
10
The following screen appears:
Fig. 19 - Selecting the Rtd type
Press the button [RTDUser] and the screen will change as follows:
10
Fig. 20 - IN A module with RtdUser selected
30
WIKA operating instructions, model Pascal ET