6. Commissioning, operation
Press [SETUP] to create a new report.
Information required are:
Report Name
■
Dut Model (Device Under Test)
■
Dut Serial Number (Device Under Test)
■
Operator
■
Job Number
■
Dry Block type
■
Found Left
■
Up Down
■
N. Points
■
First point
■
Last point
■
A standard report configuration for the calibration of a pressure transmitter 0 ... 1 bar range is available here below:
Once completed, press [STORE] to memorise the data.
WIKA operating instructions, model Pascal ET
Fig. 73 - Report setup, page 1
Fig. 74 - Report setup, page 2
EN
57