Sundries - Endress+Hauser memo-graph Version II Betriebsanleitung

If the previous values are required they should first be saved on diskette before
activating a reset (see chapter "Handling in operation - accessible functions -
diskette"). Reset becomes active as soon as the "Accept" has been acknowledged
using ("Ã").

Sundries:

• Interface values, operation modes when using PROFIBUS, test operation using
simulation (using preset unit parameters) and information of memory capacity
using the actual storage cycles.
• RS 232/RS 422/RS 485: Setting up is only required when the serial interface of the
unit is used (setting up via PC, serial data read out, modem operation, etc.).
Each unit operating with a serial interface must have its own individual address
(00...99). This is used for identification purposes by the PC software.
The transmission speed (="Baudrate") must correspond to that set in the PC software.
This setting must correspond with the settings in the PC software.
This setting must correspond with the settings in the PC software.
This setting must correspond with the settings in the PC software.
Fixed setting - cannot be changed.
Unit address
Baud rate
Parity
Stop bits
Data bits
77