Endress+Hauser memo-graph Version II Betriebsanleitung Seite 54

52
CONTENTS
1. General
2. Check before installing!
3. Safety notes/correct use
4. Installation/connection/setting up
4.1 Installation
4.2 Ambient conditions
4.3 Connections/terminal layout
4.4 Front mounted RS 232 serial interface/
serial operating cable
5. Setting up unit
5.1 Setting up directly on the unit
- Start parameter change
- The main menu
- Selection/change push buttons
- Operating principle
5.2 Setting up by PC
- PC software installation
- Advantages of setting up using a PC
5.3 Set up using diskette
5.4 List of operating parameters
- Basic settings
- Analogue inputs
- Mathematics channels (option)
- Digital inputs (option)
- Make groups
- Signal analysis
- Sundries
- Service
5.5 Programme/software update using programme diskette at the unit 81
6. Handling in operation
- Function keys/softkeys in normal operation
- Functions of the LEDs
- Internal memory
- Function of the diskette drive/data carrier change function
7. Serial interface/modem
7.1 RS 232
7.2 RS 422/RS 485
7.3 PROFIBUS DP
7.4 Setting up a modem link
8. For experienced users: Serial interface
RS 232/RS422/RS 485 transmission protocols
8.1 Setting up commands
8.2 Command for measured data read out and delete
8.3 Read out configuration data (DK)
8.4 Read out actual process data
9. Technical data
10. Accessories/consumables
Page
53
53
54
55
55
55
56
59
60
60
60
60
61
61
61
62
62
62
62
62
64
68
69
75
76
77
79
82
82
86
87
87
88
88
88
88
88
91
91
93
94
95
96
100