Inhaltsverzeichnis
Werbung
REAR SHOCK ABSORBER ASSEMBLY
3
1
a
b
= 0~2 mm
2
4. Install:
TT-R125LWE
• Rear shock absorber assembly sub-tank 1
• Screw clamp 2
• Locking tie 3
TIP
• Install the rear shock absorber assembly
sub-tank so that its bottom portion directs as
shown and lightly touches the projection a
on the frame.
• Install the rear shock absorber assembly
sub-tank with a clearance b between the
sub-tank and frame.
• Fasten the sub-tank hose with the locking tie.
Refer to "CABLE ROUTING DIAGRAM"
section in the CHAPTER 2.
5-69
CHAS
4 Nm (0.4 m · kg, 2.9 ft · lb)
Werbung
Inhaltsverzeichnis
