Yamaha 2009 TT-R125 Wartungs-Handbuch Seite 130

D After fastening the starter relay
lead, pass it on the left of the
chassis.
E Fasten the CDI magneto lead
and starter relay lead.
F Fasten the wire harness.
G Pass the rectifier/regulator lead
between the frame and air filter
case.
H Do not allow the CDI magneto
lead to slacken except between
the two plastic locking ties.
I Fasten the CDI magneto lead
over the engine bracket (rear).
J Fasten the CDI magneto lead.
CABLE ROUTING DIAGRAM
K Pass the air vent hoses
between the engine and
swingam.
L Fit the neutral switch lead
into the groove in the
crankcase cover.
M Pass the starting circuit cult-
off relay lead under the frame
and at the right of the chassis.
N Fasten the rear shock
absorber assemby sub-tank.
(TT-R125LWE only).
O Pass the CDI unit lead on the
outside of the main switch
lead, engine stop switch lead,
2-31
SPEC
clutch switch lead and start
switch lead.
P After fastening the start switch
lead, clutch switch lead,
engine stop switch lead and main
switch lead, push their corrugated
tube against the CDI unit coupler.
Q Fasten the brake hose between
the paint marks.
R Pass the brake hose (brake cable
for the TT-R125E) through the
cable guide.
S Fit the CDI unit band over the CDI
unit bracket till it stops.
T Fasten the brake cable.