Inhaltsverzeichnis
Werbung
FRONT BRAKE (TT-R125LW/TT-R125LWE)
REMOVAL POINTS
Brake fluid
1. Remove:
• Brake master cylinder cap 1
TIP
Do not remove the diaphragm.
2. Connect the transparent hose 2 to the bleed
screw 1 and place a suitable container under
its end.
3. Loosen the bleed screw and drain the brake
fluid while pulling in the lever.
NOTICE
• Do not reuse the drained brake fluid.
• Brake fluid may erode painted surfaces or
plastic parts. Always clean up spilled fluid
immediately.
Brake caliper
1. Remove:
• Brake caliper 1
TIP
Turn the brake caliper counterclockwise and pull
out it from the guide pin 2 on the brake caliper
bracket.
Brake caliper piston
1. Remove:
• Brake caliper piston
Use compressed air and proceed carefully.
WARNING
• Cover piston with rag and use extreme
caution when expelling piston from
cylinder.
• Never attempt to pry out piston.
Brake caliper piston removal steps:
• Insert a piece of rag into the brake caliper
to lock one brake caliper.
• Carefully force the piston out of the brake
caliper cylinder with compressed air.
5-14
CHAS
Werbung
Inhaltsverzeichnis
