Herunterladen Inhalt Inhalt Diese Seite drucken

Yamaha 2009 TT-R125 Wartungs-Handbuch Seite 208

Inhaltsverzeichnis

Werbung

STEERING HEAD INSPECTION AND
F
ADJUSTMENT
• Install the upper bracket A, steering stem
nut B , cap C , handlebar D , upper
handlebar holder E, starter knob nut F and
number plate G.
TIP
• The upper handlebar holder should be
installed with the punched mark a forward.
• Insert the end of fuel breather hose H into
the hole of the starter knob stay.
NOTICE
First tighten the bolts on the front side of
the handlebar holder, and then tighten the
bolts on the rear side.
Pinch bolt (upper bracket)
25 Nm (2.5 m · kg, 18 ft · lb
Steering stem nut:
110 Nm (11.0 m · kg, 80 ft · lb)
Handlebar upper holder:
23 Nm (2.3 m · kg, 17 ft · lb)
Starter knob nut:
1 Nm (0.1 m · kg, 0.7 ft · lb)
Number plate:
7 Nm (0.7 m · kg, 5.1 ft · lb)
TT-R125E/TT-R125LWE
• Steering ring nut
Steering ring nut adjustment steps:
• Remove the number plate and starter knob.
• Remove the main switch, handlebar and
upper bracket.
• Remove the special washer 1.
• Remove the upper ring nut 2, and rubber
washer 3.
• Loosen the lower ring nut 4 using the
steering nut wrench 5.
Steering nut wrench:
YU-33975/90890-01403
3-30
INSP
ADJ

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis