Inhaltsverzeichnis
Werbung
FRONT BRAKE (TT-R125LW/TT-R125LWE)
Brake master cylinder
1. Install:
• Brake master cylinder 1
• Brake master cylinder bracket 2
• Bolt (brake master cylinder bracket) 3
TIP
• Install the brake master cylinder bracket so
that the arrow mark a face upward.
• First tighten the bolts on the upper side of the
brake master cylinder bracket, and then
tighten the bolts on the lower side.
A TT-R125LW
B TT-R125LWE
2. Install:
• Brake lever 1
• Spring 2
• Bolt (brake lever) 3
• Nut (brake lever) 4
TIP
• Apply the lithium soap base grease on the
bolt and brake lever sliding surface.
• Apply the molybdenum disulfide grease on
the tip of the adjuster bolt.
Brake hose
1. Install:
• Copper washer 1
• Brake hose 2
• Union bolt 3
WARNING
Always use new copper washers.
NOTICE
Install the brake hose so that its pipe por-
tion a directs as show and lightly touches
the projection b on the brake caliper.
5-20
CHAS
9 Nm (0.9 m · kg, 6.5 ft · lb)
7 Nm (0.7 m · kg, 5.1 ft · lb)
7 Nm (0.7 m · kg, 5.1 ft · lb)
New
26 Nm (2.6 m · kg, 19 ft · lb)
Werbung
Inhaltsverzeichnis
