Inhaltsverzeichnis
Werbung
CDI MAGNETO AND STARTER CLUTCH
b
1
a
2
E
(TT-R125E/TT-R125LWE)
2
1
3
4-63
3. Install the starter clutch 1 on the rotor 2.
TIP
• Install the starter clutch with its plate portion
a facing the rotor.
• Insert the plate portion of the starter clutch
so that it is flush with the surface of contact
b with the rotor.
4. Tighten:
• Bolt (starter clutch)
30 Nm (3.0 m · kg, 22 ft · lb)
TIP
Caulk a the end of the starter clutch holding
bolt near its outer diameter to serve as a stopper.
5. Install:
• Starter wheel gear 1
• Woodruff key 2
• Rotor 3
TIP
• Clean the tapered portion of the crankshaft
and the magneto hub.
• When installing the magneto rotor, make sure
the woodruff key is properly seated in the key
way of the crankshaft.
• Apply the engine oil on the starter wheel gear
inner circumference.
6. Install:
• Plain washer 1
• Nut (magneto) 2
80 Nm (8.0 m · kg, 58 ft · lb)
TIP
Tighten the nut (magneto) while holding the
magneto with a sheave holder 3.
Sheave holder:
YS-1880-A/90890-01701
ENG
Werbung
Inhaltsverzeichnis
