Inhaltsverzeichnis
Werbung
3
1
2
ASSEMBLY AND INSTALLATION
Throttle grip assembly
1. Install:
TIP
Before applying the adhesive, wipe off grease
or oil on the tube guide surface a with a lacquer
thinner.
Handlebar
1. Install:
5
4
TIP
• Align the punched mark a on the handlebar
• The handlebar holder should be installed with
• First tighten the bolts on the front side of the
5-48
HANDLEBAR
• Collar 1
• Handlebar grip (right) 2
Apply the adhesive on the tube guide 3.
• Handlebar 1
• Handlebar holder 2
• Main switch
(TT-R125E/TT-R125LWE) 3
• Main switch holder
(TT-R125E/TT-R125LWE) 4
• Bolt (handlebar holder) 5
23 Nm (2.3 m · kg, 17 ft · lb)
with the upper surface of the handlebar holder
on the upper bracket.
the punched mark b forward.
handlebar holder, and then tighten the bolts
on the rear side.
CHAS
Werbung
Inhaltsverzeichnis
