Inhaltsverzeichnis
Werbung
CLUTCH AND PRIMARY DRIVEN GEAR
A
B
Clutch
1. Install:
• Primary driven gear 1
• Thrust plate 2
• Clutch boss 3
2. Install:
• Lock washer
• Nut (clutch boss) 1
TIP
Use the clutch holding tool 2 to hold the clutch
boss.
Clutch holding tool:
YM-91042/90890-04086
A For USA and CDN
B Except for USA and CDN
3. Bend:
• Lock washer tab
4. Install:
• Friction plate 1
• Clutch plate 2
TIP
• Install the clutch plates and friction plates
alternately on the clutch boss, starting with a
friction plate and ending with a friction plate.
• Apply the engine oil on the friction plates and
clutch plates.
• Be sure to install a clutch plate with projection
a offset approximately 90° from previous
plates projection. Continue this procedure in
a clockwise direction until all clutch plates are
installed.
4-45
ENG
New
60 Nm (6.0 m • kg, 43 ft • lb)
Werbung
Inhaltsverzeichnis
