Inhaltsverzeichnis
Werbung
CHASSIS / BRAKE SYSTEM AIR BLEEDING
(TT-R125LW/TT-R125LWE)
EC360000
CHASSIS
EC361012
BRAKE SYSTEM AIR BLEEDING
(TT-R125LW/TT-R125LWE)
Bleed the brake system if:
• The system has been disassembled.
• A brake hose has been loosened or
removed.
• The brake fluid is very low.
• The brake operation is faulty.
A dangerous loss of braking performance
may occur if the brake system is not properly
bled.
1. Remove:
• Brake master cylinder cap
• Diaphragm
2. Bleed:
• Brake fluid
Air bleeding steps:
a. Add proper brake fluid to the reservoir.
b. Install the diaphragm. Be careful not to spill
any fluid or allow the reservoir to overflow.
c. Connect the clear plastic tube 2 tightly to
the caliper bleed screw 1.
d. Place the other end of the tube into a
container.
e. Slowly apply the brake lever several times.
f. Pull in the lever. Hold the lever in position.
g. Loosen the bleed screw and allow the
lever to travel towards its limit.
h. Tighten the bleed screw when the lever
limit has been reached; then release the
lever.
i. Repeat steps (e) to (h) until of the air bubbles
have been removed from the system.
315
WARNING
Bleed screw:
6 Nm (0.6 m · kg, 4.3 ft · lb)
INSP
ADJ
Werbung
Inhaltsverzeichnis
