Inhaltsverzeichnis
Werbung
1
2
CARBURETOR
5. Install:
• Throttle shaft assembly
• Plain washer (resin) 1
• Valve lever 2
TIP
• Apply the fluorchemical grease on the
bearings.
• Make sure the stopper of the TPS spring fits
into the recess in the carburetor.
6. Install:
• O-ring
• Valve lever housing cover
• Bolt (valve lever housing cover)
7. Install:
• Pilot jet 1
• Main jet nozzle 2
• Main jet 3
• Needle valve seat 4
• Needle valve seat holder 5
• Main jet washer 6
8. Install:
• Needle valve 1
• Float 2
• Float pivot pin 3
TIP
• After installing the needle valve to the float,
install them to the carburetor.
• Check the float for smooth movement.
4-9
ENG
Werbung
Inhaltsverzeichnis
