Inhaltsverzeichnis
Werbung
PRE-OPERATION INSPECTION AND MAINTENANCE
Before riding for break-in operation or practice, make sure the machine is in good operating condi-
tion.
Before using this machine, check the following points.
GENERAL INSPECTION AND MAINTENANCE
Item
Fuel
Engine oil
Gear shifter and clutch
Throttle grip/housing
Brakes
Drive chain
Wheels
Steering
Front forks and rear shock
absorber assembly
Cables (wires)
Muffler
Sprocket
Lubrication
Bolts and nuts
Lead connectors
PRE-OPERATION INSPECTION
AND MAINTENANCE
Check that a fresh gasoline is filled in the fuel tank.
Check the fuel line for leakage.
Check that the oil level is correct.
Check the crankcase for leakage.
Check that gears can be shifted correctly in order and that the
clutch operates smoothly.
Check that the throttle grip operation and free play are
correctly adjusted. Lubricate the throttle grip and housing,
if necessary.
Check the play of front and rear brake and effect of front
and rear brake.
Check fluid level and leakage. (TT-R125LW/TT-R125LWE only)
Check chain slack and alignment.
Check that the chain is lubricated properly.
Check for excessive wear and tire pressure.
Check for loose spokes and have no excessive play.
Check that the handlebar can be turned smoothly and
have no excessive play.
Check that they operate smoothly and there is no oil leakage.
Check that the clutch and throttle cables move smoothly.
Check that they are not caught when the handlebars are
turned or when the front forks travel up and down.
Check that the muffler is tightly mounted and has no cracks.
Check that the driven sprocket tightening nut is not loose.
Check for smooth operation. Lubricate if necessary.
Check the chassis and engine for loose bolts and nuts.
Check that the CDI magneto, CDI unit, and ignition coil
are connected tightly.
3-3
Routine
INSP
ADJ
Page
P.1-12
P.3-7 ~ 10
P.3-4
P.3-4 ~ 5
P.3-15 ~ 20
P.3-21 ~ 22
P.3-27 ~ 28
P.3-28 ~ 32
P.3-23 ~ 26
--
P.4-2
P.3-20
P.3-33
-
P.1-5
Werbung
Inhaltsverzeichnis
