Herunterladen Inhalt Inhalt Diese Seite drucken

Yamaha 2009 TT-R125 Wartungs-Handbuch Seite 210

Inhaltsverzeichnis

Werbung

STEERING HEAD INSPECTION AND
G
ADJUSTMENT
• Tighten the lower ring nut 6 using steering
nut wrench 7 and turn the steering right
and left a few times.
TIP
Set the torque wrench to the steering nut
wrench so that they form a right angle
.
Steering nut wrench:
YU-33975/90890-01403
Lower ring nut (initial tightening):
38 Nm (3.8 m · kg, 27 ft · lb)
• Loosen the lower ring nut one turn.
• Retighten the lower ring nut using the
steering nut wrench.
WARNING
Avoid over-tightening.
Ring nut (final tightening):
20 Nm (2.0 m · kg, 14 ft · lb)
• Check the steering stem by turning it lock
to lock. If there is any binding, remove the
steering stem assembly and inspect the
steering bearings.
• Install the rubber washer 8, upper ring nut
9 and special washer 0.
TIP
• Tighten the upper ring nut until it contacts
the rubber washer.
• Insert the special washer pawls into the
slots. If the slots are not aligned, tighten the
upper ring nut for alignment.
• Install the upper bracket A, steering stem
nut B , cap C , handlebar D , upper
handlebar holder E, main switch F, starter
knob nut G and number plate H.
TIP
• The upper handlebar holder should be
installed with the punched mark a forward.
• Insert the end of fuel breather hose I into
the hose clamp.
3-31
INSP
ADJ

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis