Inhaltsverzeichnis
Werbung
FUSE INSPECTION (TT-R125E/TT-R125LWE)
6. Install:
• Battery
7. Check:
• Battery terminals
Dirt → Clean with a wire brush.
Loose connection → Connect properly.
8. Lubricate:
• Battery terminal
Recommended lubricant:
Lithium soap base grease
9. Connect:
• Battery leads
(to the battery terminals)
NOTICE
First, connect the positive lead 1, then the
negative lead 2.
10. Install:
• Battery cover
FUSE INSPECTION
(TT-R125E/TT-R125LWE)
NOTICE
To avoid a short circuit, always set the main
switch to OFF when checking or replacing a
fuse.
1. Remove:
• Battery cover
2. Check:
• Continuity
Checking steps:
• Remove the fuse 1.
• Connect the pocket tester to the fuse and
check the continuity.
TIP
Set the pocket tester selector to "Ω×1".
Pocket tester:
YU-03112-C/90890-03112
• If the pocket tester indicates "∞", replace
the fuse.
2 Reserve fuse
3-41
INSP
ADJ
Werbung
Inhaltsverzeichnis
